Skip to product information
1 of 3

FrogCube Limited

40 Gallon Sliding Horizontal Kit

40 Gallon Sliding Horizontal Kit

Regular price $82.99 USD
Regular price Sale price $82.99 USD
Sale Sold out
<iframe src="https://www.youtube.com/embed/Fq-Hskmv9U8" width="560" height="315" frameborder="0" allowfullscreen="allowfullscreen"></iframe>

Part kits are custom 3D printed to fit on Aqueon 40 gallon breeder aquariums, converting them to front opening horizontal terrariums. Made from PLA plastic, these kits allow for easy installation, removable glass doors, and above/below door ventilation. This kit also contains four holes made for a Mistking misting assembly. A cover is included to close the hole when not being used. Adhesive handles for the glass are also included.

You will still need to purchase an Aqueon 40B gallon aquarium (usually available for $50 during the dollar per gallon sale at Petco), single pane glass (3/32-inches which is also 2.2mm) doors and base, as well as silicone.

Design is subject to change.

GLASS IS NOT INCLUDED

You will need two pieces of single strength glass (2.2mm or 3/32-inches) cut:

DOOR: (2) 12" x 18" (12"x36" piece of single strength glass (2.2mm or 3/32-inches) cut in half)
BASE: 3" x 35-3/8" (may be up to 3mm or 1/8-inch in width for those who want to use acrylic)

Cut your glass specs or modify as needed for use as terrariums, vivariums and ripariums.

Glass sizing subject to change. Do your own measuring to be sure.

Be sure to use fine sand paper on the sharp edges and corners. Corners must be sanded down to avoid them biting into the plastic.)
View full details